Set consists of dark green plastic lawn edging with two affixed strips of thin, self-adhesive aluminium tape and a controller device for 9V battery.
length 9m, height 15 cm.
The strips of current-carrying aluminum foil were additionally reinforced with a copper wire laid underneath, so that the mechanical load capacity was considerably improved.
Any disturbances, i.e. interruption, short circuit or too low battery voltage, are indicated by the red LED.
.
Also included is a repair kit with an LED and approx. 50 cm self-adhesive aluminum tape with a current-conducting acrylic adhesive layer so that you can make an electrical connection with this adhesive tape, on possible breaks.
All screws used are made of stainless steel.
The controller device must be connected to a 6LR61 9V battery, which is not supplied.
! ATTENTION IMPORTANT !
After installation, open the device and insert the battery.
Before closing and screwing on the cover, please check that no cable is pinched and that the seal is correctly attached.
Please mount the control unit in the shade if possible, in case of solar version, only align the solar panel to the sun.
Any contamination on the aluminium strips, such as dried snails, snail slime or bird droppings, please do not scrape off, but soften with a little water and wipe off damp, otherwise the aluminium layer may be damaged.
This Product was added to our catalogue on 08/09/2015.